Default Remote Managment on Linksys

joe_chicken

Just a quick question,

I enabled remote management on my Linksys G router,
here it is
I left the port as the default, but can't remember it...

Anyone know what the default port is?

Wcool

Here is your user guide:

ftp://ftp.linksys.com/pdf/wcg200_ug.pdf

I browsed through it, but it doesn't seem to mention remote administration??
How did you do that?

Most routers I know use port 8080 though... Give that a try

joe_chicken

Wcool wrote:

Here is your user guide:

ftp://ftp.linksys.com/pdf/wcg200_ug.pdf

I browsed through it, but it doesn't seem to mention remote administration??
How did you do that?

Most routers I know use port 8080 though... Give that a try

Thanks...
Tried 8080, no joy...

Remote Managment is under the administration tab..
I think it was 5401... or 54001... or something

O well.. will be home soon... will check it out then

Wcool

If you don't remember the port anymore, you can always reset the router to its factory defaults, and start over again