Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Gas heating problem - reset button

Options
  • 08-12-2008 5:09pm
    #1
    bittihuduga
    Registered Users Posts: 1,904 ✭✭✭


    hi
    the gas heating was off for few days as i was away from home
    came back and switched on the heating...it didnt on
    my landlord had told how to fix it..but i forgot..

    he is not in country as of now..and not on ph :-(

    i removed the circuit box
    there is coin shaped reset button
    sometimes some water comes out(one or 2 drops)

    any one knows where is this reset button?


Comments

  • Options
    #2
    Victor
    Registered Users Posts: 78,443 ✭✭✭✭Victor


    Moved from Accommodation & Property.

    What is the make and model of the boiler?


  • Options
    #3
    [Deleted User]
    Posts: 0 ✭ [Deleted User]


    What gas boiler is it?


  • Options
    #4
    bittihuduga
    Registered Users Posts: 1,904 ✭✭✭bittihuduga


    i removed the safety box..
    it said colladato on it...
    as far my memory, this was common on this boiler
    i was told to remove the safety
    and then on it there is coin shaped i was told to rotate...
    on that it say SIME
    does it help?


  • Options
    #5
    [Deleted User]
    Posts: 0 ✭ [Deleted User]


    If the boiler gauge is below 1 then you will have to top up the water by reaching underneath and turning a small tap making sure you turn it off at about 11/2, this is what the manual says=


    Insufficient water pressure
    In case the index of the thermomanometer is below scale of the blue colour (2)the boiler is not functioning and the orange
    bicolour detector is flashing. To restore
    functioning act on the filling cock
    taking the index of the manometer within
    the scale of the blue colour.

    Once filled close the filling tap.


    If you need to reset the boiler then you have to twist the knob to the left of the red light if it's on, again this is what the manual says=

    Ignition failure/safety stat interception
    If the burner fails to start the red led that signals blockage will light up. To
    attempt starting it again, the rotary switch
    must be turned to the position (flame ) and released soon after, returning to the
    summer ( sun)or winter (snow flake )position.

    If the failure should occur again, call
    the authorised technical staff to check
    the boiler.


    good luck, Gary


  • Options
    #6
    bittihuduga
    Registered Users Posts: 1,904 ✭✭✭bittihuduga


    thanks Gary for the info
    now which is the filling cock?
    i have the same problem as mentioned above
    there was a knob with a open pipe and i turned and some water came out....
    but no change in meter setting

    where is the tap to rotate and fill water?


  • Advertisement
  • Options
    #7
    bittihuduga
    Registered Users Posts: 1,904 ✭✭✭bittihuduga


    problem fixed..all sorted now..thanks for your help :-)


Advertisement