If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Pro Plus 43cc Brusch Cutter Problem

SF09 · 2010-09-21 18:27:31

Hello, I have recently bought the item above, It started fine the first time I used it. Now it won't start, Ive checked the fuel mix, primed it, set the unit to start. Its starts sometimes then cuts out. Any suggestions how to get this thing going would be appreciated.

Options

21-09-2010 7:27pm

#1

SF09

Registered Users Posts: 5 ✭

Join Date: March 2009

Posts: 3

Hello,

I have recently bought the item above, It started fine the first time I used it. Now it won't start, Ive checked the fuel mix, primed it, set the unit to start. Its starts sometimes then cuts out.

Any suggestions how to get this thing going would be appreciated.

0

Comments

Options
#2 21-09-2010 10:00pm
FarmerGreen

Registered Users Posts: 1,134 ✭✭✭

Join Date: May 2008

Posts: 986

Ignition off, choke on, full throttle, three pulls.
Ignition on, one pull. If it fires set half choke,if not give it another pull.
Choke off, full throttle, pull fast until it starts.
The trick is to pull fast enough to get a good spark with a reasonable mixture of air/petrol.
Its a good idea not to stand wih your back to a pebble dashed wall when you perform this violent manoeuvre.
You need to rotate the engine way above idle speed to get it to fire up,
dont be girly with it.

0
Options
#3 20-10-2010 3:31pm
Pason

Registered Users Posts: 95 ✭✭

Join Date: February 2009

Posts: 49

had same problem check that all screws on carberator are tight this was my problem

0