OFCH Control Panel .... Help

Kat1170

Mods not sure if this should go in Elec. or plumbing & heating, move if necessary .

I bought my OFCH system new a few years ago but am only getting around to fitting it now. Any dia. for the control panel is long gone, if there ever was one .
I have my pump wired up to run full time. Anyone able to help with wiring the control panel to the burner? I can see where the P+ and N- come in, but am at a loss as where they come from to go to the burner.

There are three probes that plug in to the boiler. They are Red, White and black.
The White goes to the Temp guage.
The Red one goes to a reset button
The Black one goes to the Min. Max temp control switch.

I'm hoping that it is a simple the wires go here, here and here answer but

Any extra pics needed or any questions fire away. Thanks in advance ....

Sticker


Wiring board


wiring board 2


Control panel front


Wiring


Wiring overview


Wiring

liveandnetural

very good picture....but what make and model is it.....looks like a ferroli

Kat1170

Unfortunately I haven't a clue. Only info I have is in the pic's
Was just hoping someone might have one, or have fitted one.

meercat

pic of the burner
and any connections/leads etc

Kat1170

Will throw some up Sun. as working tomorrow. Cheers

meercat

also a picture of complete housing(stand back and take it)
cheers

Kat1170

Front cover of control panel


Front of control panel minus cover


Boiler, location of 3 probes top right corner.


Make of boiler


Control panel from above and behind


Three Temp. probes


Boiler wiring


Boiler


Complete unit


Hope these are of some help. Any more info I can supply, just shout. Cheers Joe.

meercat

http://www.cumbriaheating.co.uk/cgi-bin/trolleyed_public.cgi?action=showprod_IDEALCLIMA005

try downloading the pdf here

meercat

e-mail: info@idealclima.org
maybe contact them and ask for wiring diagram
if you get it ,post it up and i will see what i can do

meercat

i would take a guess at red and black probes connect to boiler casing
white probe is frost stat protection
(its only a guess though)

if you wire the panel with live and neutral in as marked,then by turning the switches on/off up/down you should be able to determine which numbers 1-6 are the correct connections for the burner controls

(at your own risk)

Kat1170

E-mails sent, will let you know if I get anything back.

Model turns out to be a Idealclima Logica 3.

Kat1170

Very impressed. Installation and maintenance manuals received from IdealClima first thing this morning. A fair bit of info to check, but it all seems to be there. Big thanks to all here for the help. I'll let you know when it is all (hopefully ) installed.

meercat

Kat1170 wrote: »

Very impressed. Installation and maintenance manuals received from IdealClima first thing this morning. A fair bit of info to check, but it all seems to be there. Big thanks to all here for the help. I'll let you know when it is all (hopefully ) installed.

now thats service

Roger69

Kat1170, could you perhaps share the info Ideal Clima sent you?
I've got the same boiler and the same problem but they didn't react to my e-mail.

Thanks in advance :-)

Kat1170

No Problem. Just PM me your e-mail address and I'll send you on the instructions I received from them.

Kat1170

e-mail sent.