Rear right light replacement. Possible recall of issue?

DarraghR

I have a Nissan Primera 2004 hatchback and am experiencing a loss of power to my engine when indicating right. This is due to a know problem with this model.

Its seems the wiring on the circuit board can melt or become damaged over time.

I have found a full head lamp in a scrap yard for €50 which is quite good but could there be a recall for this issue through a official Nissan dealer? Where might I find out online?

biko

I suppose ringing a dealer with the VIN could work. I don't know if that info is available online for Ireland.

bren11

This is the fix you are looking for;

http://www.npoc.co.uk/forum/p12-rear-light-removal-now-with-simple-earth-fix_topic16533_post233467.html#233467

I did it on both left and right tail lights. Also used solder where wire is wrapped around earth in light cluster, to make good contact. I found plastic around earth pin loose on the yellow socket in picture.

9935452

DarraghR wrote: »

I have a Nissan Primera 2004 hatchback and am experiencing a loss of power to my engine when indicating right. This is due to a know problem with this model.

Its seems the wiring on the circuit board can melt or become damaged over time.

I have found a full head lamp in a scrap yard for €50 which is quite good but could there be a recall for this issue through a official Nissan dealer? Where might I find out online?

Ring a main dealer and ask.
The problem is the car is 11 years old, they probably wont want to know

DarraghR

bren11 wrote: »

This is the fix you are looking for;

http://www.npoc.co.uk/forum/p12-rear-light-removal-now-with-simple-earth-fix_topic16533_post233467.html#233467

I did it on both left and right tail lights. Also used solder where wire is wrapped around earth in light cluster, to make good contact. I found plastic around earth pin loose on the yellow socket in picture.

Thanks for the link will be getting help off a house mate later. NCT is Tuesday so hopefully will get it sorted

DarraghR

Tried cleaning the circuit board but that didnt help. I did notice the wiring from the car to light was slightly uncovered. Thinking about changing it out for a fresh one. How would i go about removing the sealant and putting it back on. Have provided a few pictures below. Maybe someone will notice something I didnt

http://s18.postimg.org/ouq1oi8dl/image.jpg
http://s18.postimg.org/qvgl9c4ix/image.jpg
http://s14.postimg.org/mgpyo2loh/image.jpg
http://s28.postimg.org/yn6hz0d4d/image.jpg
http://s27.postimg.org/vbj2yifw3/image.jpg