Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back a page or two to re-sync the thread and this will then show latest posts. Thanks, Mike.

Fabrication/wielding advice.

  • 15-05-2015 11:52am
    #1
    peter05
    Registered Users, Registered Users 2 Posts: 334 ✭✭


    Hi Guys,

    I am searching for some recommendations for a fabricator/wielder in the Mullingar area.

    Torlerances are very very low for this project
    If the fabrication is out buy 1mm the parts are pretty useless.
    The wielding needs to very very clean.

    I also need to have a feedscrew made.
    I have had this feedscrew fabricated before so I know its possible.
    It is a buttress thread with some fine details 456mm in lenght.
    Again tolerances needs to be very very low.

    There is a fair bit of detail needed.
    So, I guess am searching for someone who I can work with overtime and will care for the detail in he project. Its not a huge project by any means just might be a little time consuming.

    Hope someone can point me in the right direction.

    Best
    Peter


Advertisement