Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

gobbledegook, can anyone explain this

Options
  • 28-12-2016 11:15am
    #1
    Dulchie
    Registered Users Posts: 209 ✭✭


    I tried to install a F2000 modem yesterday to replace a failing F1000 
    I ran into the following message.

    Confirm

    "You attempt to set Internate to Link Up Set Refresh interval to regain 
    WAN connection status"


                                                                   Cancel    OK

    Does anyone know what this means, eir technical support were baffled !


Comments

  • Options
    #2
    Dulchie
    Registered Users Posts: 209 ✭✭Dulchie


    Dulchie wrote: »
    I tried to install a F2000 modem yesterday to replace a failing F1000 
    I ran into the following message.

    Confirm

    "You attempt to set Internate to Link Up Set Refresh interval to regain 
    WAN connection status"


                                                                   Cancel    OK

    Does anyone know what this means, eir technical support were baffled !
    Finally solved the F1000 only need 100Base-T cat wiring.

    However the F2000 needs a fully populated cable.

    Therefor the F2000 could not see the fibre termination box.

    Solution KN had to replace the existing fibre to F2000 router cabling
    before the F2000 could communicate with the fibre box.

    Which means a direct swap from the F1000 to the F2000 depends
    whether or not the original cat 5 cable was fully connected  !


  • Options
    #3
    Eir: Pamela
    Closed Accounts Posts: 2,797 ✭✭✭Eir: Pamela


    Dulchie wrote: »
    Dulchie wrote: »
    I tried to install a F2000 modem yesterday to replace a failing F1000 
    I ran into the following message.

    Confirm

    "You attempt to set Internate to Link Up Set Refresh interval to regain 
    WAN connection status"


                                                                   Cancel    OK

    Does anyone know what this means, eir technical support were baffled !
    Finally solved the F1000 only need 100Base-T cat wiring.

    However the F2000 needs a fully populated cable.

    Therefor the F2000 could not see the fibre termination box.

    Solution KN had to replace the existing fibre to F2000 router cabling
    before the F2000 could communicate with the fibre box.

    Which means a direct swap from the F1000 to the F2000 depends
    whether or not the original cat 5 cable was fully connected  !
    [font=Verdana, sans-serif]Thanks for the update [/font][font=Verdana, sans-serif] [/font][font=Verdana, sans-serif]Dulchie,[/font][font=Verdana, sans-serif] [/font][font=Verdana, sans-serif]glad you got it sorted.[/font]
    [font=Verdana, sans-serif] [/font]
    [font=Verdana, sans-serif]-Pamela [/font]

    [font=Verdana, sans-serif] [/font]


Advertisement