Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

A new timer switch / programmer for my setup

Options
  • 07-11-2017 11:38pm
    #1
    PeWu79
    Registered Users Posts: 119 ✭✭


    So my current setup is as follows

    (Gravity system with water tanks at the attic and hot water cylinder in the hot press)
    Boiler: Vokera Mynute 24m
    Timer: APT IMM24
    2 x Thormostast (upstairs + downstairs) + 2 x valves
    1 x Cylinder Thermostat + valve

    I can see 3 cables going to the timer - power (blue + brown), boiler (blue + brown) and Thermostats/vales (blue + brown).
    I guess both HW and CH are combine into 1 channel (am I right?)


    As the timer is a typical immersion heater time switch the boiler can only be controlled by the timer - regardless any of the thermostats.
    So it goes on at certain time even if there is no need for HW or CH.

    What I want to achieve is the bolier goes on only if the timer is on *and* any of the theromstats/valves calls for heat.



    Could you please advise what programmer I should get for my setup and how I should wire it?


Advertisement