Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

SPC5300 Battery Low

Options
  • 22-07-2020 3:44pm
    #1
    fergalom
    Registered Users Posts: 113 ✭✭


    SPC 5300 panel is showing a "battery low" message on kepad.

    Loggin into panel and extract below is from the status info page:

    Power
    Mains: OK
    Mains time sync.: OK (50Hz)
    Battery: Fault
    Battery Voltage: N/A
    Battery Current: N/A
    Aux. Voltage: 13.2V
    Aux. Current: 100mA
    Aux. Fuse: OK
    Ext.Bell Fuse: OK
    Int. Bell Fuse: OK


    Its been in a number of years (diy install) so is it feasible it would just need replacing or likely a loose connection?

    Asking first as panel is not in the most accessible locations.


Comments

  • Options
    #2
    altor
    Registered Users Posts: 11,713 ✭✭✭✭altor


    fergalom wrote: »
    SPC 5300 panel is showing a "battery low" message on kepad.

    Loggin into panel and extract below is from the status info page:

    Power
    Mains: OK
    Mains time sync.: OK (50Hz)
    Battery: Fault
    Battery Voltage: N/A
    Battery Current: N/A
    Aux. Voltage: 13.2V
    Aux. Current: 100mA
    Aux. Fuse: OK
    Ext.Bell Fuse: OK
    Int. Bell Fuse: OK


    Its been in a number of years (diy install) so is it feasible it would just need replacing or likely a loose connection?

    Asking first as panel is not in the most accessible locations.

    Have you replaced the back up battery?

    www.altor.ie



Advertisement