Notching of 9” x 2” joist for 40mm waste pipe

Kealyboy

Hi,

Can i notch out a 9” x 2” timber joist for 40mm waste pipe to sit flush with the top of the joist?

I am a bit concerned about notching out too much and compromising the structural integrity of the joist.

thank you

dathi

https://www.youtube.com/watch?v=y7QSTOTMymU

here

Car99

If you're really worried screw a 16" lenght of 4x2 to the 9×2 below the notch.

jimf

i would go with a hole through the middle of the joist

Calahonda52

https://www.boards.ie/discussion/comment/119595587#Comment_119595587

Not very practical if the pipe is of any length

MrMusician18

TGD Part A has the rules you need

https://www.thermodial.ie/wp-content/uploads/2016/10/Holes-and-Notches-in-Joists-RECI.pdf&ved=2ahUKEwjvh-K3ooj6AhX1nVwKHWQ2AgEQFnoECA0QAQ&usg=AOvVaw1k1-Bkl148IArV4aLZUsQx

jimf

https://www.boards.ie/discussion/comment/119596697#Comment_119596697

agree without seeing the application

Sleeper12

I agree with Jimf. It's far better to bore a hole in the middle of the joists. Using flexible waste pipe is a good option. One meter length in the link below but it comes in much longer length

https://www.lenehans.ie/catalog/product/view/id/230163/s/40mm-flexi-pipe-1m/?gclid=Cj0KCQjw6_CYBhDjARIsABnuSzqGuLIZyqa81jOo9rnxsZ2TJP6XZ0LUrQyLbrkjO4NWc-Tj4BG6jLEaAhcfEALw_wcB

Kealyboy

Thanks for all the replies. If I do notch it it shouldn’t be major issue really would it.

Kealyboy

How many people actually abide by these regs 😕😂

Kealyboy

If I turn my trap facing this way in picture. I can then come of the trap with a 40mm waste elbow through the centre of the joist. Regs state that the hole be no larger than 1/4 size of the joist. Joist is 9 inch, so I am allowed to drill a hole in the centre up to 56mm.