Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Leaking Toilet Cistern

  • 06-01-2023 5:01pm
    #1
    Registered Users, Registered Users 2 Posts: 656 ✭✭✭


    Hi.

    The toilet overflow is leaking from the cistern into the toilet. When it flushes the gray arm pops up which I assume should then stop the water filling but water keeps coming in and out the overflow pipe.

    Any idea what can be done to stop it please?




Best Answers

  • Registered Users, Registered Users 2 Posts: 5,391 ✭✭✭DublinDilbert


    Sounds like an issue with the inlet valve on the RHS over filling the cistern. Many of these contain a diaphragm washer which can be changed, but you will need to get exactly the right one, shut off the water and strip down the unit. Sometimes the diaphragm washer is expensive, so you are almost best buying the completed unit. Check out the likes of screwfix for inlet values, they have the complete units from about €10 upwards.



  • Registered Users, Registered Users 2 Posts: 5,391 ✭✭✭DublinDilbert


    It’s probably not too bad. Buy an identical one, take it apart and remove the washer, shut off water and put it into your own.



  • Registered Users, Registered Users 2 Posts: 10,071 ✭✭✭✭dodzy


    If you isolate the water supply, you can disconnect the internal part of the inlet mechanism easy enough. Most have a retaining clip along the lower section inlet pipe, once released the complete mechanism can be lifted off, but you leave the actual inlet piper in situ. If you can get a like for like replacement, you can avoid the need to drain down the cistern and having to replace the inlet part of the unit. Unlikely to be a diaphragm washer. A failed one typically results in a very restricted refill flow, not the opposite.



Answers

  • Registered Users, Registered Users 2 Posts: 656 ✭✭✭ingalway


    Thank you. I was hoping it might be something easier.



  • Registered Users, Registered Users 2 Posts: 593 ✭✭✭triona1


    I've had this problem if you push down the yellow part and hold it the cistern will fill then release the yellow part up to the blue part.



Advertisement