Part Arm Inhibits

xxdiceyxx

I am looking for help to make changes to add/remove inhibits in part arm A on a Hkc 1070 system.

I only have wireless motion sensors which I see in the system as Points not Zones.

I have engineer code and would be very grateful if someone could guide me through the process.

Thanks

altor

https://www.boards.ie/discussion/2058357235/part-arm-inhibits

In the point menu, select options for each point you want to inhibit in part set A/B.

Pguard A select Y to be off in that part set, same with B

xxdiceyxx

Hi altor I went into point options as suggested..selected for eg sunroom then the letter Y just flashes I don't Pg see A or B

xxdiceyxx

Just

Inhibit

Exc psa

Exc psb

Soak

Chime

Rem. Test

So is psa and psb is where the dirty deed is done, eg press psa in sunroom then N to remove from part set

altor

https://www.boards.ie/discussion/comment/122303296#Comment_122303296

Yes, you need to press yes for the Y to change from N (no) in EXC PSA

This will turn off the device in Part Set

xxdiceyxx

Many thanks for your time altor much appreciated 👍

altor

https://www.boards.ie/discussion/comment/122303375#Comment_122303375

You're welcome