Magnetic strength - hex bit holders

drury..

Is there ones you can buy with a decent magnetic strength

They're always too weak as long as I've been using them

Alun

Be careful what you wish for, I've one that's so strong you need a pair of pliers to get the bits out!

drury..

https://www.boards.ie/discussion/comment/122350152#Comment_122350152

🙂 I've a Milwaukee impact set you need a pliers to get the bits out of the plastic holders

Seriously though I'd be using pozi 2 90% of the time

Mr321

Your correct the magnets are useless on most but I've this Milwaukee impact now a few months and it's very good. I see the price is reduced now from when I bought so might buy a other 😁

https://www.screwfix.ie/p/milwaukee-shockwave-1-4-hex-magnetic-bit-holder-60mm/669jr

Gen.Zhukov

Got this little set included with a power tool years ago - It's a belt & braces approach. Holder is magnetic and the black knurled piece is spring loaded and locks the bit in -

The Continental Op

That set looks very like a Wera set?

https://www.amazon.co.uk/Wera-05057423001-1%C3%82-Set-12%C3%82-Pieces-Multi-Colour/dp/B01BNGH0SY

Wera are also know for doing a decent magnetic bit holder this one is a bit belt and braces with an internal grip ring.

https://www.amazon.co.uk/Wera-Universal-Holder-retaining-05073357001/dp/B0006JJSIA

Mr321

https://www.boards.ie/discussion/comment/122357848#Comment_122357848

These type bit holders are very handy, I've a few but only for use on drills. Impact drivers damage the spring loaded rings like these.

The Continental Op

A cheaper one if you have Amazon Prime

https://www.amazon.co.uk/Wera-5347100001-Universal-Magnetic-Multi-Colour/dp/B000Y8WANI/

drury..

I've the wera and the shockwave handy there and neither are very strong magnetically

The shockwave set is a design disaster anyway you have to prise the bits out with a pliers I saw someone else posting that so should have known what to expect

Gen.Zhukov

https://www.boards.ie/discussion/comment/122357899#Comment_122357899

Yep, the Wera brand seem to have a great reputation across the board. I think @Mr321 is talking about the holders that have a wire/spring around the middle of the inside (like an int circlip) - I've had those but the int spring pops out too easy

On closer inspection, the metabo one above has 1 tiny ball bearing doing the heavy lifting - If I lift the knurled piece the ball recedes allowing bit to be removed

Slightly updated version of that set is available

https://www.ebay.de/itm/380522852904

The Continental Op

For most use I have a load of cheap magnetic hex bit holders that have never been a problem and hold on to the bit just fine. Occasionally the bit is left in the screw head if it gets stuck but thats fairly rare. I suspect the cheap bit holders I have came as part of a massive very cheap chinese Rolson bit set.