Vehicle issue

fiweldon · 18-01-2022 1:23pm #1

Hi can someone help me please ,I have a 2010 Mercedes sprinter van that keeps going into limp mode ,I have an OBD reader and can erase the fault code and it drives brilliantly but when I turn off the engine the problem is back .I’ve had 3 different mechanics check it over but nothing is working,sensors have been changed dpf is fine diesel filter has been changed and diesel tank has been cleaned ,does anyone have any ideas of what else this could be as nobody seems to be able to fix it .I would really appreciate anyone’s feedback

thanks

Esel · 18-01-2022 10:44pm

Wrong forum. You should post here:

https://www.boards.ie/categories/motors

Boards.ie: Niamh · 20-01-2022 2:34pm

Welcome to Boards @fiweldon I have moved your query to the Motors forum where you might get some helpful answers.

Miscreant · 20-01-2022 3:13pm

What code are you clearing the whole time and have you looked into what it means?

fiweldon · 20-01-2022 5:45pm

Thanks for getting back to me ,the machine I have is a very cheap one so it won’t even show a Mercedes vehicle only gives me the option to erase code or not ,not sure what code mechanics are getting sorry ,because there doesn’t seem to be any problem with the engine do you think it could be an electrical problem,when I erase the code it goes like a bomb ,is it safe to continue doing this do you think

thanks so much

blade1 · 20-01-2022 5:51pm

Could be a vacuum leak or something.

Were the mechanics you used not able to scan for codes?

fiweldon · 20-01-2022 5:58pm

Hi thanks the mechanic also thought a vacuum leak but it wasn’t ,what ever code they got brought him to the sensors which he changed ,he’s now asked someone he knows to maybe check the electrical end ,he’s actually annoyed he can’t find the issue ,could it be the Ecu panel or am I saying that wrong 🥴,thanks

blade1 · 20-01-2022 6:02pm

The code would be handy to know.

Did he mention anything about it running lean or anything?

CreadanLady · 20-01-2022 6:08pm

The code only gives a very general idea of the issue. I could be anything - a frayed wire, a single corroded or bad terminal in 40 pin connector block, a dry solder joint on a PCB, corrupted software, etc.

Often these types of issues are very difficult to resolve. For an older vehicle, a bad connection or frayed wire that could be fixed in 5 minutes with a bit of tape, simply cannot be found without expending an unreasonable amount of time in labour. Very often this leaves an otherwise good vehicle a write of for scrap. I scrapped a Kangoo van with less than 100k miles on the clock because of an intractable intermittent electrical fault that just couldn't be pinned down without a labour cost that wasn't a large part of the van's value.

fiweldon · 20-01-2022 10:04pm

https://www.boards.ie/discussion/comment/118507496#Comment_118507496

Oh my god thanks for being so honest ,we’ve even spent money on turning it into a Campervan

fiweldon · 20-01-2022 10:05pm

https://www.boards.ie/discussion/comment/118507461#Comment_118507461

Hi sorry what does running lean mean , thanks

Vehicle issue

Comments