HKC RF SABB Bell Battery Replacement

So is that 12 batteries in total to replace the batteries in the bell-box? Thank you?

Very helpful as always - big thank you!

Sorry to jump on here, but I've the same issue, and replacing the 6 CR123A batteries in the bell box pack (and one AA on a little device with flat black metal "chip" sitting inside the bell box) hasn't cleared the problem.

When I go into the engineer menu, devices log says that it's SB1 Sabb Battery Low.

I've tried going to the battery menu and doing "Replace Battery", to clear the fault, but this doesn't seem to do anything.

Every time I set/unset, the voice message comes on "Device battery needs replacing, call engineer", and the device status of the SB1 Sabb still shows low battery, despite 6 brand new ones.

Any ideas?

Should I have done something before replacing the batteries?

e: I saw someone mention in another thread to put the system into engineer mode first, so I went into the engineer menu, then disconnected the battery pack for a minute, put it back in, closed up bell box enclosure, came out of engineer menu, but the message still persists.

Bell box is wireless with single battery pack: https://i.imgur.com/geRfyw8.jpg

This is the device with an AA battery inside (wrapped in black tape) and the black (magnetic?) chip with it: https://i.imgur.com/Acqkzjv.jpg

That replacement option is for the battery in the quantum control panel and would have no effect on the external bell.

If you have replaced the batteries and the fault does not clear straight away then the bell itself is the issue I'm afraid.