Source for fasteners for Glen L Malahini

B593 · 07-08-2023 2:12pm #1

Hi, I'm new to Boards. I hope I'm posting in the correct forum.

I'm just ready to start cutting the frames for my Malahini. Glen L recommend silicone bronze or hot dipped galvanised screws, nails and bolts. I'm kinda shocked at the cost of silicone bronze screws etc. Does anyone have a reasonably affordable source for these items?

Or maybe there are cheaper alternatives?

Regards

Paul

fergal.b · 07-08-2023 2:31pm

These are good https://www.inox.ie/index.html and https://www.chmarine.com/marine-grade-fasteners/?gclid=Cj0KCQjwrMKmBhCJARIsAHuEAPT58MBC9TALODdCcWD4OcgDGUpRKIm68IZsQAV5Yfs3D5qplpW6vc4aAhsXEALw_wcB you can also get them in from the UK but unless you have an address up north the customs charge can be mad. You wont need many screws or nails as most of the bonding is done by the epoxy using a lot of clamps. I also used some plastic raptor nails that can be sanded. Great to see another one getting built, be sure to keep us posted. If you are on Facebook join up here https://www.facebook.com/groups/176294473704038 lots of boat builders with help and advice.

https://www.youtube.com/watch?v=Qd6vkPjEy4U

B593 · 07-08-2023 2:43pm

I thought you'd be the first to reply Fergal 😊 I've been following all your stories re Crackerbox, engine restorations etc. If my boat finishes half as good as yours I'll be more than happy.

Did you use ilicone bronze or hot dipped galvanised screws/nails?

thanks,

Paul

fergal.b · 07-08-2023 2:47pm

https://www.boards.ie/discussion/comment/120949221#Comment_120949221

I just used stainless steel.

B593 · 07-08-2023 2:59pm

Oh, Glen L advises against stainless steel. Where you not concerned about the crevice corrosion mentioned?

fergal.b · 07-08-2023 3:24pm

https://www.boards.ie/discussion/comment/120949257#Comment_120949257

No most of the screws I used were removed after the joint was glued and set then the screw holes filled with epoxy.

B593 · 07-08-2023 3:30pm

Great, that's a big money saver!. Thanks.

fergal.b · 07-08-2023 3:34pm

https://www.boards.ie/discussion/comment/120949346#Comment_120949346

Buy more clamps 😁

AndyBoBandy · 07-08-2023 5:55pm

Just to add I bought some SS bolts from Inox last year, and they are top notch…

Source for fasteners for Glen L Malahini

Comments